Corolla L4-2.4L (2AZ-FE) (2010)
NOTICE:
Be careful not to allow brake fluid to enter the removed connector.
(b) Remove the bolt.
(c) Using a union nut wrench (10 mm), disconnect the 6 brake lines from the actuator assembly.
(d) Use tags or make a memo to identify the places to reconnect.
HINT
*
*1: To front wheel cylinder RH
*
*2: To front wheel cylinder LH
*
*3: To rear wheel cylinder RH
*
*4: To rear wheel cylinder LH
*
*5: From 1st of master cylinder
*
*6: From 2nd of master cylinder
(e) Remove the 2 bolts, nut and the brake actuator with bracket from the body.