Corolla L4-2.4L (2AZ-FE) (2010)
Torque : 29 Nm (296 kgf-cm, 21 ft-lbf)
(b) Install a new clip to the front flexible hose.
NOTICE:
Install the clip as far as it will go.
(c) Using a union nut wrench (10 mm), connect the brake line to the front flexible hose while holding the flexible hose with a wrench.
without a union nut wrench - Torque : 15 Nm (155 kgf-cm, 11 ft-lbf)
with a union nut wrench - Torque : 14 Nm (143 kgf-cm, 10 ft-lbf)
NOTICE:
*
Do not kink or damage the brake line.
*
Do not allow any foreign matter such as dirt or dust to enter the brake line from the clip or bracket.
*
Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).
*
This torque value is effective when the union nut wrench is parallel to the torque wrench.
(d) Install the front flexible hose to the absorber bracket with the bolt.
Torque : 29 Nm (296 kgf-cm, 21 ft-lbf)
HINT
Install the speed sensor harness bracket first and then the front flexible hose.
2. FILL RESERVOIR WITH BRAKE FLUID See: Brake Fluid/Service and Repair
3. BLEED BRAKE LINE See: Brake Fluid/Service and Repair
4. INSPECT FOR BRAKE FLUID LEAK