Corolla L4-2.4L (2AZ-FE) (2010)
3. INSTALL NO. 1 CAMSHAFT BEARING See: Service and Repair/Overhaul/Reassembly
4. INSTALL NO. 2 CAMSHAFT BEARING See: Service and Repair/Overhaul/Reassembly
5. INSTALL CAMSHAFT See: Service and Repair/Overhaul/Reassembly
6. INSTALL NO. 2 CAMSHAFT See: Service and Repair/Overhaul/Reassembly
7. CONNECT INLET HEATER WATER HOSE See: Service and Repair/Removal and Replacement/Engine Assembly/Installation
8. CONNECT OUTLET HEATER WATER HOSE See: Service and Repair/Removal and Replacement/Engine Assembly/Installation
9. CONNECT NO. 1 RADIATOR HOSE See: Service and Repair/Removal and Replacement/Engine Assembly/Installation
10. CONNECT ENGINE WIRE
(a) Connect the ground cable with the bolt.
Torque : 8.4 Nm (86 kgf-cm, 74 in-lbf)
(b) Connect the camshaft position sensor connector.
(c) Connect the engine coolant temperature sensor connector.
(d) Connect the engine oil pressure switch connector.
(e) Connect the radio setting condenser connector.
(f) Connect the heater water inlet hose.
11. INSTALL NO. 2 CHAIN SUB-ASSEMBLY
(a) Set the crankshaft key in the left horizontal position.
(b) Turn the cutout of the drive shaft so that it faces upward.