Corolla L4-2.4L (2AZ-FE) (2010)
Exhaust Pipe: Service and Repair
Installation
2AZ-FE INTAKE / EXHAUST: EXHAUST PIPE: INSTALLATION
1. INSTALL FRONT EXHAUST PIPE ASSEMBLY
(a) Using a vernier caliper, measure the free length of the compression springs.
HINT
If the free length is less than the minimum, replace the compression spring.
(b) Remove the remains of exhaust manifold converter with wire brash.
(c) Fully insert a new gasket to the exhaust manifold.
NOTICE:
*
Be sure to install the gasket in the correct direction.
*
Do not reuse the gasket.
*
Do not damage the gasket.
(d) Install the front exhaust pipe assembly with the 2 bolts and 2 compression springs.
Torque : 43 Nm (440 kgf-cm, 32 ft-lbf)