Corolla L4-2.4L (2AZ-FE) (2010)
Oil Pressure Sender: Service and Repair
Installation
2AZ-FE LUBRICATION: OIL PRESSURE SWITCH: INSTALLATION
1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY
(a) Apply adhesive to 2 or 3 threads of the oil pressure switch.
Adhesive:
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
(b) Using a 24 mm deep socket wrench, install the oil pressure switch.
Torque : 15 Nm (153 kgf-cm, 11 ft-lbf)
NOTICE:
Do not start the engine for at least 1 hour after installation.
(c) Connect the oil pressure switch connector.
2. INSTALL AIR CLEANER CAP SUB-ASSEMBLY WITH HOSE See: Powertrain Management/Fuel Delivery and Air Induction/Throttle
Body/Service and Repair/Installation
3. INSPECT FOR OIL LEAK