Corolla L4-2.4L (2AZ-FE) (2010)
Backup Lamp Switch: Service and Repair
Removal
E351 MANUAL TRANSMISSION / TRANSAXLE: BACK-UP LIGHT SWITCH: REMOVAL
1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine Assembly/Removal
2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY See: Powertrain Management/Fuel Delivery and Air Induction/Throttle Body/Service and
Repair/Removal
3. REMOVE AIR CLEANER CASE See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Removal
4. DISCONNECT WIRE HARNESS
(a) Disconnect the terminal 50 connector from the starter assembly.
(b) Remove the nut and disconnect the wire harness from terminal 30.
(c) Disconnect the wire harness clamp.
5. REMOVE BACK-UP LIGHT SWITCH ASSEMBLY
(a) Disconnect the back-up light switch connector.
(b) Using SST, remove the back-up light switch and gasket from the transaxle case.