Corolla L4-2.4L (2AZ-FE) (2010)
/Page-999083.png)
NOTICE:
*
The resistance must be measured after the CAN No. 2 junction connector is reconnected.
*
The resistance must be measured after the CAN No. 1 junction connector is disconnected.
Standard Resistance:
(d) Except TMC made:
(1) Measure the resistance according to the value(s) in the table below.
NOTICE:
*
The resistance must be measured after the CAN No. 2 junction connector is reconnected.
*
The resistance must be measured after the CAN No. 1 junction connector is disconnected.
Standard Resistance:
NG -- CHECK FOR SHORT TO GND IN CAN BUS WIRE (CAN NO. 1 JUNCTION CONNECTOR - POWER STEERING
ECU)
OK -- Continue to next step.
7. CHECK FOR SHORT TO GND IN CAN BUS WIRE (STEERING ANGLE SENSOR BRANCH WIRE)
(a) TMC made:
