Corolla L4-2.4L (2AZ-FE) (2010)
Crankshaft Position Sensor: Service and Repair
Installation
2AZ-FE ENGINE CONTROL: CRANKSHAFT POSITION SENSOR: INSTALLATION
1. INSTALL CRANK POSITION SENSOR
(a) Apply a light coat of engine oil to the O-ring on the crank position sensor.
(b) Install the crank position sensor with the bolt.
Torque : 9.0 Nm (90 kgf-cm, 80 in-lbf)
NOTICE:
Do not twist the O-ring.
(c) Install the wire harness and crank position sensor connector clamp.
(d) Connect the crank position sensor connector.
2. INSTALL GENERATOR ASSEMBLY See: Starting and Charging/Charging System/Alternator/Service and Repair/Removal and
Replacement/Installation
3. INSTALL V-RIBBED BELT See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and
Repair/Installation
4. INSTALL ENGINE UNDER COVER RH
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL See: Fuel Delivery and Air Induction/Fuel Injector/Service and
Repair/Installation
6. INSPECT FOR OIL LEAK