Corolla L4-2.4L (2AZ-FE) (2010)
(1) With the belt assembly installed, check that the belt locks when it is pulled out quickly.
6. CONNECT FRONT SEAT OUTER BELT ASSEMBLY RH (for Front Passenger Side)
(a) Install the floor end of the front seat outer belt assembly with the front seat belt anchor base.
Torque : 41 Nm (420 kgf-cm, 30 ft-lbf)
(b) Engage the clamp.
(c) Connect the connector.
(d) Check if the ELR locks.
NOTICE:
The check should be performed with the outer belt assembly installed.
(1) With the belt assembly installed, check that the belt locks when it is pulled out quickly.
7. INSTALL LAP BELT OUTER ANCHOR COVER (for Driver Side)
(a) Engage the 3 claws and install the lap belt outer anchor cover.
8. INSTALL LAP BELT OUTER ANCHOR COVER (for Front Passenger Side)
(a) Engage the 2 guides.
(b) Engage the 2 claws and install the lap belt outer anchor cover.