Corolla L4-2.4L (2AZ-FE) (2010)
/Page-1620004.png)
3. INSTALL STARTER COMMUTATOR END FRAME ASSEMBLY
(a) Fit the clamp of the brush holder into the starter commutator end frame assembly.
(b) Install the commutator end frame with the 2 screws.
Torque : 1.5 Nm (15 kgf-cm, 13 in-lbf)
4. INSTALL STARTER ARMATURE ASSEMBLY
(a) Align the rubber with the groove of the starter yoke assembly.
(b) Install the starter armature with the brush holder onto the starter yoke assembly.
NOTICE:
The magnet of the starter yoke assembly may attract the starter armature assembly when the starter commutator end frame assembly
is installed, causing the magnet to break.
HINT
Support the starter armature so that it may not be pulled out from the starter brush holder by magnetic force of the starter yoke
assembly.
5. INSTALL STARTER ARMATURE PLATE
(a) Install the starter armature plate onto the starter yoke assembly.
