toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Steering - Clunk/Pop Noise When Turning|Page 6260 > < Steering - Clunk/Pop Noise When Turning|Page 6254
Page 1
background image

Steering Shaft: Customer Interest
Steering - Clunk/Pop Noise When Turning

T-SB-0243-09

July 31, 2009

Steering Intermediate Shaft Knocking Noise

Service Category
Steering

Section
Steering Gear/Linkage

Market
USA

Applicability

Introduction

Some 2009 - 2010 Corolla and Matrix vehicles may exhibit a clunk pop or knocking noise when turning the steering wheel to the left or right. A new
intermediate shaft has been developed to address this condition. Use the following repair procedure to remove and replace the steering intermediate
shaft.

Production Change Information

This TSB applies to vehicles produced BEFORE the Production Change Effective VINs shown below.

Warranty Information

APPLICABLE WARRANTY

^ This repair is covered under the Toyota Comprehensive Warranty. This warranty is in effect for 36 months or 36,000 miles, whichever occurs first,

from the vehicle's in-service date.

Steering - Clunk/Pop Noise When Turning|Page 6260 > < Steering - Clunk/Pop Noise When Turning|Page 6254