Corolla L4-2.4L (2AZ-FE) (2010)
12. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
13. INSTALL COLUMN HOLE COVER SILENCER SHEET See: Steering/Steering Column/Service and Repair/Removal and
Replacement/Installation
14. INSTALL FRONT WHEELS
Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)
15. STABILIZE SUSPENSION
(a) Lower the vehicle and bounce it up and down several times to stabilize the front suspension. Raise the vehicle.
16. FULLY TIGHTEN FRONT LOWER SUSPENSION ARM LH
(a) Fully tighten the bolt (A).
Bolt type (1) - Torque : 137 Nm (1397 kgf-cm, 101 ft-lbf)
Bolt type (2) - Torque : 145 Nm (1479 kgf-cm, 107 ft-lbf)
NOTICE:
The final torque must be applied under standard vehicle height conditions.
(b) Fully tighten the bolt (B).
Bolt type (1) - Torque : 137 Nm (1397 kgf-cm, 101 ft-lbf)
Bolt type (2) - Torque : 145 Nm (1479 kgf-cm, 107 ft-lbf)
NOTICE:
*
The final torque must be applied under standard vehicle height conditions.
*
Because the nut has its own stopper, do not turn the nut. While securing the nut, tighten the bolt B.
17. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
HINT
Inspect and adjust front wheel alignment See: Alignment/Service and Repair