Corolla L4-2.4L (2AZ-FE) (2010)
11. INSTALL FRONT HOOK ASSEMBLY
(a) Install the front hook assembly with the 2 bolts.
Torque : 39 Nm (398 kgf-cm, 29 ft-lbf)
12. CONNECT FRONT LOWER SUSPENSION ARM LH See: Ball Joint/Service and Repair/Installation
13. CONNECT FRONT LOWER SUSPENSION ARM RH
HINT
Perform the same procedure as the LH side.
14. CONNECT FRONT STABILIZER LINK ASSEMBLY LH See: Suspension Strut / Shock Absorber/Service and Repair/Front Shock
Absorber/Installation
15. CONNECT FRONT STABILIZER LINK ASSEMBLY RH
HINT
Perform the same procedure as the LH side.
16. CONNECT TIE ROD END SUB-ASSEMBLY LH See: Steering/Steering Gear/Service and Repair/Installation
17. CONNECT TIE ROD END SUB-ASSEMBLY RH
HINT
Perform the same procedure as the LH side.
18. INSTALL ENGINE UNDER COVER LH
19. INSTALL ENGINE UNDER COVER RH
20. CONNECT NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY See: Steering/Steering Gear/Service and Repair/Installation
21. CONNECT NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY See: Steering/Steering Column/Service and Repair/Removal and
Replacement/Installation
22. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
23. INSTALL COLUMN HOLE COVER SILENCER SHEET See: Steering/Steering Column/Service and Repair/Removal and
Replacement/Installation
24. INSTALL FRONT WHEELS
Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)
25. STABILIZE SUSPENSION See: Control Arm/Service and Repair/Installation
26. FULLY TIGHTEN FRONT LOWER SUSPENSION ARM LH See: Control Arm/Service and Repair/Installation
27. FULLY TIGHTEN FRONT LOWER SUSPENSION ARM RH
HINT
Perform the same procedure as the LH side.