Corolla L4-2.4L (2AZ-FE) (2010)
Tire Pressure Monitor Receiver / Transponder: Service and Repair
Installation
TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING RECEIVER: INSTALLATION
1. INSTALL TIRE PRESSURE WARNING ANTENNA AND RECEIVER
(a) Connect the connector.
(b) Install the tire pressure warning antenna and receiver with the bolt.
Torque : 7.5 Nm (76 kgf-cm, 66 in-lbf)
HINT
Engage the 2 tabs into the holes as shown in the illustration to install the tire pressure warning antenna and receiver.
2. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Installation
3. INSTALL ROOF SIDE INNER GARNISH BOARD LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Installation
4. INSTALL REAR SEAT SIDE GARNISH LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Installation
5. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Installation
6. INSTALL REAR DOOR SCUFF PLATE LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Installation
7. INSTALL REAR SEATBACK ASSEMBLY LH See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seat
Assembly/Installation
8. INSTALL REAR SEAT CUSHION ASSEMBLY See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seat
Assembly/Installation
9. INSTALL REAR SEAT HEADREST ASSEMBLY LH
10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
11. INSPECT TIRE PRESSURE WARNING SYSTEM