Corolla L4-2.4L (2AZ-FE) (2010)
4. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Rear Disc Brake)
HINT
*
for Manual Transaxle See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and Replacement/Removal
*
for Automatic Transaxle See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and
Replacement/Removal
5. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for Rear Disc Brake)
HINT
*
for Manual Transaxle See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and Replacement/Removal
*
for Automatic Transaxle See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and
Replacement/Removal
6. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (for Rear Disc Brake) See: Body and Frame/Interior Moulding /
Trim/Console/Service and Repair/Removal and Replacement/Removal
7. LOOSEN PARKING BRAKE CABLE (for Rear Disc Brake) See: Brakes and Traction Control/Disc Brake System/Service and Repair/Removal
and Replacement/Rear Brake (for Disc Type)/Removal
8. REMOVE PARKING BRAKE LEVER PROTECTOR (for Rear Disc Brake) See: Brakes and Traction Control/Parking Brake System/Parking
Brake Cable/Service and Repair/Parking Brake Cable (for Rear Disc Brake)/Removal
9. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY (for Rear Disc Brake) See: Brakes and Traction Control/Disc Brake
System/Service and Repair/Removal and Replacement/Rear Brake (for Disc Type)/Removal
10. REMOVE REAR BRAKE DRUM (for Rear Drum Brake) See: Brakes and Traction Control/Drum Brake System/Service and Repair/Removal
and Replacement/Removal
11. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY (for Rear Disc Brake)
(a) Remove the 2 bolts, and separate the rear disc brake caliper assembly.
NOTICE:
Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.
12. REMOVE REAR DISC (for Rear Disc Brake) See: Brakes and Traction Control/Disc Brake System/Service and Repair/Removal and
Replacement/Rear Brake (for Disc Type)/Removal
13. REMOVE REAR AXLE HUB BOLT (for Rear Drum Brake)
(a) Temporarily install the 2 nuts and 2 washers to the rear axle hub bolt as shown in the illustration.
(b) Using SST and a brass bar or an equivalent tool to hold the hub and bearing assembly, remove the rear axle hub bolt.
SST : 09611-12010