Corolla L4-2.4L (2AZ-FE) (2010)
NOTICE:
The bearing should be completely installed.
2. INSTALL FRONT DRIVE SHAFT DUST COVER (for 2WD)
(a) Using SST and a press, install a new drive shaft dust cover.
SST : 09527-10011
SST : 09726-40010
Distance (A):
27.1 mm (1.067 in.)
3. INSTALL FRONT DRIVE SHAFT DUST COVER RH (for 2WD)
(a) Using SST and a press, install a new drive shaft dust cover RH until the distance from the tip of the center drive shaft to the drive shaft dust
cover RH meets the specification, as shown in the illustration.
SST : 09527-10011
Distance (A):
90.07 to 90.93 mm (3.5460 to 3.5799 in.)
NOTICE:
*
The dust cover should be completely installed.
*
Be careful not to damage the dust cover.
4. INSTALL FRONT DRIVE SHAFT DUST COVER LH
(a) Using SST and a press, install a new dust cover into the front drive inboard joint assembly until it is flush with the end.