Corolla L4-2.4L (2AZ-FE) (2010)
(f) Install the outer part of the transmission control cable to the shift lever retainer, check that the position of the spring is the same as A shown in
the illustration, and push in the stopper.
HINT
If the stopper cannot be pushed in, slightly rotate the nut clockwise and then push in the stopper.
(g) Push the two claws together at the top of the transmission control cable lock piece. While holding the two claws together, push the two lugs on
the bottom of the lock piece toward each other and upward to pull out the lock piece.