Corolla CE Sedan 4-Door L4-1587cc 1.6L DOHC MFI (1997)
Brake Caliper: Service and Repair
Removal and Installation
Front Brake Components
REMOVAL
Removing Union Bolt And Disconnecting Flexible Hose
1. Disconnect flexible hose.
(a) Remove the union bolt and 2 gaskets from the Caliper, then disconnect the flexible hose from the Caliper.
Torque: 30 Nm (22 ft. lbs.)
NOTE: Install the flexible hose lock securely in the lock hole in the Caliper.
(b) Use a container to catch the brake fluid as it drains out.
2. Remove Caliper from torque plate.
Hold the sliding pin and loosen the 2 installation bolts, and remove the installation bolts.
Torque: 34 Nm (25 ft. lbs.)
3. Remove these parts:
(a) 2 anti-squeal springs.
(b) 2 Brake Pads with anti-squeal shims.
(c) 2 4 pad support plates.
INSTALLATION
Installation is in the reverse order of removal.
