Corolla CE Sedan 4-Door L4-1587cc 1.6L DOHC MFI (1997)
b. Install the pump with the 3 bolts. Torque the bolts to 14 Nm (10 ft. lbs.).
c. Connect the inlet hose to the water pump, and install the water inlet No.2 to the cylinder head with the 2 nuts. Torque to 14.5 Nm (11 ft. lbs.).
d. Connect the water temperature sender gauge connector.
2. Install oil dipstick guide and dipstick as follows:
a. Install a new O-ring on the oil dipstick guide.
b. Apply small amount of engine oil to the O-ring.
c. Push in the oil dipstick guide with the O-ring.
d. Install the mounting bolt. Torque to 9.3 Nm (82 inch lbs.).
e. Connect the crankshaft position sensor connector to the dipstick guide.
3. Connect engine wire. Connect the engine wire with the bolt and 2 nuts.
4. Install electric cooling fan.
5. Install front engine mounting insulator.
a. Install the front engine mounting insulator, through-bolt and nut. Torque to 87 Nm (64 ft. lbs.).
b. Install the 2 bolts to the mounting. Torque to 64 Nm (47 ft. lbs.).
c. Install the hole cover.
6. Install No. 2 and No. 3 timing belt covers.
7. Install RH engine mounting insulator.
8. Fill radiator with engine coolant.
9. Start engine and check for leaks.
