Corolla CE Sedan 4-Door L4-1587cc 1.6L DOHC MFI (1997)
(f) Connect the fuel return hose to the fuel outlet of the pressure regulator.
(g) Install the grommet and O-ring to the injector.
(h) Connect SST (union and hose) to the injector, and hold the injector and union with SST (clamp). SST 09268-41045
(i) Put the injector into the graduated cylinder.
HINT: Install a suitable vinyl hose onto the injector to prevent gasoline from splashing out.
(j) Connect the TOYOTA hand-held tester to the DLC3.
(k) Turn the ignition switch ON and TOYOTA hand-held tester main switch ON.
NOTICE: Do not start the engine.
(l) Select the active test mode on the TOYOTA hand-held tester.
(m)Please refer to the TOYOTA hand-held tester operator 5 manual for further details.
(n) If you have no TOYOTA hand-held tester, connect the positive (+) and negative (-) leads from the battery to the fuel pump connector.
(o) Reconnect the negative (-) terminal cable to the battery.
(p) Turn the ignition switch ON.
NOTICE: Do not start the engine.
(q) Connect SST (wire) to the injector and battery for 15 seconds, and measure the injection volume with a graduated cylinder. Test each injector
2 or 3 times. SST 09842-30070
Volume:39 - 49 cub.cm(2.4 - 3.0 Cu in.) per 15 sec.
Difference between each injector: 5 cub.cm (0.3 Cu in.) or less
If the injection volume is not as specified, replace the injector.
2. INSPECT LEAKAGE
(a) In the condition above, disconnect the test probes of SST (wire) from the battery and check the fuel leakage from the injector. SST
09842-30070
