Corolla CE Sedan 4-Door L4-1587cc 1.6L DOHC MFI (1997)
Wheel Bearing: Service and Repair
Front
Disassembly
NOTE: Remove steering knuckle prior to performing the following procedure, refer to Steering and Suspension.
1. Remove dust deflector, using a screwdriver.
2. Remove lower ball joint.
a. Remove the cotter pin and nut.
b. Using Special Service Tool (SST) 09628 - 62011, remove the lower ball joint.
3. Remove the inner oil seal using SST 09308 - 00010.
4. Remove snap ring Using snap ring pliers.
5. Remove axle hub.
a. Using SST 09520 - 00031, remove the axle hub from the steering knuckle.
b. Remove the inner race (inside).
c. Using SST 09950 - 40010, remove the inner race (outside) from the axle hub.
6. Remove brake dust cover, Using a torx wrench (T30), remove the 3 bolts and dust cover.
