Corolla CE Sedan 4-Door L4-1587cc 1.6L DOHC MFI (1997)
Power Window Circuit Breaker: Testing and Inspection
INSPECT POWER WINDOW CIRCUIT BREAKER OPERATION
Driver's Door and Rear Right Side Door
1. Disconnect the connector from the power win do switch.
2. Connect the positive (+) lead from the battery to terminal 1 and the negative (-) lead to terminal 5 on the wire harness side connector, and raise the
window to full closed position.
3. Continue to apply voltage, and check that there is a circuit breaker operation noise within approximately 4 to 40 seconds.
4. Reverse the polarity, and check that the window begins to descend within approximately 60 seconds. If operation is not as specified, replace the
motor.
Passenger's Door
1. Disconnect the connector from the power window switch.
2. Connect the positive (+) lead from the battery 1 terminal 1 and the negative (-) lead to terminal 4 on the wire harness side connector, and raise the
window to full closed position.
3. Continue to apply voltage, and check that there is a circuit breaker operation noise within approximately 4 to 40 seconds.
4. Reverse the polarity, and check that the window begins to descend within approximately 60 seconds. If operation is not as specified, replace the
motor.
