Corolla FX L4-1839cc DSL (1CLC) (1986)
/Page-262002.png)
Fig. 6 Valve body bolt identification. A240E & A241E models, 1988
5.
Position valve body in installation position, then insert and finger tighten attaching bolts. Torque bolts to 7 ft. lbs. Attaching bolt lengths (mm)
are indicated in Figs. 4, 5 and 6.
6.
On except A130L and A131L models, connect solenoid connector.
7.
On A130L and A131L models, align manual valve with pin on manual valve lever, then install manual valve body.
Fig. 7 Manual valve body bolt identification
8.
Insert and finger tighten attaching bolts, then torque 7 ft. lbs. Attaching bolt lengths (mm) are indicated in Fig. 7.
9.
On all models, install detent spring, then insert and finger tighten attaching bolt. Torque attaching bolt to 7 ft. lbs.
10.
Ensure manual lever is in contact with center of roller at tip of detent spring, then install oil tubes.
11.
On except A130L and A131L models, install and tighten tube clamp attaching bolt.
12.
On A130L and A131L models, install apply tube bracket.
13.
On all models, install oil strainer.
14.
Insert magnet into pan, then install oil pan with new gasket.
15.
Insert oil pan attaching bolts, then torque to 43 inch lbs.
16.
Install drain plug with new gasket, then torque to 36 ft. lbs. on A130L and A131L models or 13 ft. lbs. on except A130L and A131L models.
17.
Fill transaxle to specifications, then ensure proper fluid level.
