Corolla LE Sedan L4-1.8L (1ZZ-FE) (1999)
/Page-491008.png)
2) Using SST and a hammer, tap in a new oil seal until its surface is flush with the timing chain cover edge.
SST 09309-37010
3) Apply MP grease to the oil seal lip.
b. If timing chain cover is installed to the cylinder block.
1) Using a knife, cut off the oil seal lip.
2) Using a screwdriver, pry out the oil seal.
NOTICE: Be careful not to damage the crankshaft. Tape the screwdriver tip.
3) Using SST and a hammer, tap in the oil seal until its surface is flush with the timing chain cover edge.
SST 09309-37010
INSTALLATION
1. INSTALL CAMSHAFT TIMING SPROCKETS
a. Align the camshaft knock pin with the knock pin groove on the sprocket side with timing mark, and slide on the timing sprocket.
