Corolla LE Sedan L4-1.8L (1ZZ-FE) (1999)
/Page-339001.png)
Alignment: Service and Repair
Rear
INSPECTION
1. MEASURE VEHICLE HEIGHT
2. INSTALL CAMBER-CASTER-KINGPIN GAUGE OR POSITION VEHICLE ON WHEEL ALIGNMENT TESTER
Follow the specific instructions of the equipment manufacturer.
3. INSPECT CAMBER
Camber:
If the measured value is not within the specified value, inspect the suspension parts for damage and/or wear and replace them if necessary because
camber is not adjustable.
Measuring Point Reference
4. INSPECT TOE-IN
Toe-in:
If the toe-in is not within the specified value, adjust it at the
No. 2 lower suspension arm.
5. ADJUST TOE-IN
a. Measure the lengths of the right and left No. 2 lower suspension arms.
No. 2 lower suspension arm length difference: 1 mm (0.04 inch) or less
If the right-left difference is greater than the specified value, adjust the length.
