Corolla LE Sedan L4-1.8L (1ZZ-FE) (1999)
/Page-1169002.png)
c. Check to see that there is no remarkable play in the radial direction of the inboard joint.
d. Check the boots for damage.
2. REMOVE INBOARD JOINT BOOT CLAMPS
a. Using pliers, pinch the claw A and B to compress the large inboard joint boot clamp and remove it.
b. Employ the same manner described above to the smaller one.
c. Slide the inboard joint boot toward the outboard joint.
3. REMOVE INBOARD JOINT SHAFT
a. Place matchmarks on the inboard joint shaft, tripod and outboard joint shaft.
NOTICE: Do not punch the marks.
b. Remove the inboard joint shaft from the outboard joint shaft.
4. REMOVE TRIPOD
a. Using a snap ring expander, remove the snap ring.
b. Place matchmarks on the outboard joint shaft and tripod.
NOTICE: Do not punch the marks.
c. Using a brass bar and hammer, remove the tripod from the outboard joint shaft.
NOTICE: Do not tap the roller.
5. REMOVE INBOARD JOINT BOOT
6. RH drive shaft: REMOVE DYNAMIC DAMPER
a. Using a side cutter, cut the dynamic damper clamp and remove it.
b. Remove the dynamic damper.
7. REMOVE OUTBOARD JOINT BOOT
a. Using pliers, pinch the claws to compress the small outboard joint boot clamp and remove it.
b. Using a side cutter, cut the large boot clamp and remove it.
c. Remove the outboard joint boot.
