Corolla LE Sedan L4-1762cc 1.8L DOHC MFI (1998)
4. With ABS: Bleed ABS actuator if equipped.
Using Special Service Tool (SST) 09843-18020 or equivalent, connect terminals Tc, Ts and E1 of DLC1.
b. Turn the ignition switch ON.
c. Check the air bleed mode display by blinking of ABS warning light on the combination meter.
HINT: ABS warning light blinks every 1.5 secs. as shown in the illustration to show that ABS ECU is in the air bleed mode.
d. Depress the brake pedal and hold it.
HINT: Do not depress the brake pedal at this moment.
f.
Do not depress the brake pedal several times.
e. 1 second after depressing the brake pedal, check that the pressure reduction solenoid operates for 0.5 sec. and the pedal reaches the end.
HINT: Continue to depress the brake pedal until pedal end.
f.
Release the brake pedal.
g. After 0.5 sec., check that the motor operates for 1.5 sec.
HINT: Do not depress the brake pedal at this moment.
h. Check the air bleed mode display with blinking pattern of ABS warning light on the combination meter.
1. If the display is OK as shown in the illustration, go to step i.
2. If the display is NG as shown in the illustration, turn the ignition switch OFF then repeat the operation from step 4-b again.
