Corolla LE Sedan L4-1762cc 1.8L DOHC MFI (1998)
1. INSTALL AIRBAG SENSOR ASSEMBLY
a. Using a torx wrench, install the airbag sensor assembly with 3 screws.
Torx wrench: T40 (Part No.09042-00020 or locally manufactured tool)
Torque: 20 N.m (200 kgf.cm, 14 ft.lbf)
b. Connect the airbag sensor connectors.
NOTICE:
^
Make sure the sensor assembly is installed to the specified torque.
^
If the sensor assembly has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor
assembly with a new one.
^
When installing the sensor assembly , take care that the SRS wiring does not interfere with other parts and is not pinched between other parts.
^
After installing, shake the sensor assembly to check that there is no looseness.
2. INSTALL THESE PARTS:
a. Lower center finish panel
b. Rear console box
c. M/T:
Shifting hole cover
d. A/T:
Shifting hole bezel
e. Stereo opening cover
f.
Center cluster finish panel
g. Lower RH panel
h. Lower panel
i.
Lower LH insert
j.
Lower finish panel
k. Cowl side trims
l.
Front door scuff plates
Side Airbag Sensor Assembly
REMOVAL
NOTICE: Do not open the cover or the case of the ECU and various computers unless absolutely necessary.
(If the IC terminals are touched, the IC may be destroyed by static electricity.)
1. REMOVE THESE PARTS:
a. Front door scuff plate
b. Center pillar lower garnish
2. REMOVE FRONT SEAT OUTER BELT RETRACTOR
a. w/ Seat Belt Pretensioner:
Disconnect the pretensioner connector.
b. LH side only:
Disconnect the retractor switch connector.
c. Remove the 2 bolts and retractor.
