Corolla LE Sedan L4-1762cc 1.8L DOHC MFI (1998)
Seat Belt Tensioner: Service and Repair
Removal
SEAT BELT PRETENSIONER REMOVAL
NOTICE:
^
If the wiring connector of the supplemental restraint system is disconnected with the Ignition switch at ON or ACC, diagnostic trouble codes
will be recorded.
^
Never use SRS parts from another vehicle. When replacing parts, replace with new parts.
1. REMOVE THESE PARTS:
(a) Front door scuff plate
(b) Center pillar lower garnish
2. REMOVE FRONT SEAT OUTER BELT
CAUTION: Never disassemble the front seat outer belt.
NOTICE: When removing the front outer seat belt, take care not to pull the seat belt pretensioner wire harness.
(a) Remove the bolt and floor anchor.
(b) Using a screwdriver, remove the anchor caps.
HINT: Tape the screwdriver tip before use.
(c) Remove the bolt and shoulder anchor.
(d) Disconnect the pretensioner connector as shown in the illustration.
(e) LH side only: Disconnect the retractor switch connector.
(f) Remove the 2 bolts and front seat outer belt.