Corolla LE Sedan L4-1762cc 1.8L DOHC MFI (1998)
Transmission Position Switch/Sensor: Service and Repair
PARK/NEUTRAL POSITION (PNP) SWITCH
ON-VEHICLE REPAIR
1. REMOVE LH ENGINE UNDER COVER
2. DISCONNECT SHIFT CABLE FROM CONTROL SHIFT LEVER
3. DISCONNECT PARK/NEUTRAL POSITION SWITCH CONNECTOR
4. REMOVE PARK/NEUTRAL POSITION SWITCH
a) Remove the control shaft lever.
b) Pry out the lock washer and remove the manual valve shaft nut.
c) Remove the 2 bolts and pull out the park/neutral position switch.
5. INSTALL AND ADJUST PARK/NEUTRAL POSITION SWITCH
a) Install the park/neutral position switch with 2 bolts to the control valve shaft.
Torque: 5.4 Nm (55 kgf-cm; 48 in. lbs.)
b) Install a new lock plate and tighten the nut.
Torque: 6.9 Nm (70 kgf-cm; 61 in. lbs.)
c) Stake the nut with lock plate.
d) Install the control shift lever and nut.
Torque: 12 Nm (120 kgf-cm; 9 ft. lbs.)
6. CONNECT PARK/NEUTRAL POSITION SWITCH CONNECTOR
7. CONNECT SHIFT CABLE TO CONTROL SHIFT LEVER
Torque: 12 Nm (120 kgf-cm; 9 ft. lbs.)
8. CHECK PARK/NEUTRAL POSITION SWITCH OPERATION