Corolla LE Sedan L4-1762cc 1.8L DOHC MFI (1998)
REASSEMBLY
NOTICE: When using a vise, do not overtighten it.
1. Coat with; power steering fluid.
2. Install vane pump shaft with bearing.
a. Wind vinyl tape on the serrated part of the vane pump shaft.
b. Using SST 0960-04031, press in the shaft with the bearing.
NOTICE: Be careful not to damage the oil seal.
c. Using snap ring pliers, install a new snap ring to the front housing.
3. Install straight pins.
Using a plastic hammer, tap in 2 new pins to the front housing.
NOTICE: Be careful not to damage the pins.
4. Install cam ring.
Install the ring with the inscribed mark facing outward.
HINT: Align the holes of the cam ring with the straight pins.
5. Install vane pump rotor.
Install the rotor with the inscribed mark facing outward.
6. Install vane plates and gasket.
a. Install the 10 plates with the round end facing outward.
b. Install a new gasket on the front housing.
NOTICE: Be careful the direction of the gasket.
7. Install side plate.
a. Coat a new O-ring with power steering fluid and install it to the plate.
b. Align the holes of the plate and straight pins, and install the orate.
