Corolla S Sedan L4-1.8L (1ZZ-FE) (2002)
/Page-154003.png)
Torque: 20 N.m (205 kgf.cm, 15 ft.lbf)
NOTE:
-
Connection of the connector is done with the sensor assembly installed.
-
Make sure the sensor is installed with the specified torque.
-
If the sensor has been dropped, or there are cracks, dents or other defects in the case, brackets or connector, replace the removed sensor
with new one.
-
The front sensor is equipped with an electrical connection check mechanism. Be sure to lock this mechanism securely when connecting the
connector. If the connector is not securely locked, a malfunction code will be detected by the diagnostic system.
b. Connect the front airbag sensor connector.
2. INSTALL LH UNDER COVER
3. INSTALL RH FRONT TURN SIGNAL LIGHT
4. INSTALL RH HEADLIGHT
