Corolla S Sedan L4-1794cc 1.8L DOHC MFI (2001)
2. REMOVE PISTON FROM CYLINDER
a. Put a piece of cloth or equivalent between the piston and the caliper.
b. Use compressed air to remove the piston from the cylinder.
CAUTION: Do not place your fingers in front of the piston when using compressed air.
3. REMOVE PISTON SEAL FROM CYLINDER
Using a screwdriver, remove the piston seal.
4. REMOVE SLIDING PINS AND DUST BOOTS
a. Remove the 2 sliding pins from the torque plate.
NOTICE: At the time of reassembly, please refer to the item. Insert the sliding pin with sliding bushing into the lower part, and insert the
sliding pin without sliding bushing into the upper part.
b. Using a screwdriver and hammer, tap the 2 dust boots.
HINT: At the time of reassembly, use a 19 mm socket and hammer, tap in the 2 new dust boots.
NOTICE: At the time of reassembly, please refer to the item. Confirm that the metal plate portion of the dust boot fits snugly in the torque
plate.
INSPECTION
1. MEASURE PAD LINING THICKNESS
