Corolla Sedan L4-1587cc 1.6L DOHC (4A-F) (1987)
/Page-184003.png)
10. Set No.1 cylinder at TDC/Compression.
(a) Turn the crankshaft pulley and align its groove with the No.1 timing belt cover.
(b) Check that the valve lifters on the No.1 cylinder are loose. If not, turn the crankshaft pulley one complete revolution.
11. Remove RH engine mounting insulator.
(a) Set the jack to the engine.
NOTE: Place a wooden block between the jack and engine.
(b) Remove the three bolts and mounting stay.
(C) Remove the bolt, two nuts, through bolt and RH mounting.
12. Remove water pump pulley.
13. Remove crankshaft pulley.
