Corolla Sedan 4-Door L4-1587cc 1.6L DOHC MFI (1997)
Hydraulic Control Assembly - Antilock Brakes: Testing and Inspection
1. Inspect battery positive voltage.
Battery positive voltage: 10-14Volts
2. Remove Windshield Washer Tank.
3. Disconnect connectors.
(a) Disconnect the 2 connectors from the Control Relay.
(b) Disconnect the connector from the Actuator.
4. Connect Actuator checker Special Service Tool (SST).
Connecting Actuator Checker To Actuator
(a) Connect the Actuator checker (SST) to the Actuator, Control Relay and body side wire harness through the sub-wire harness C and I (SST), as
shown.
SST O9990-OO150, 09990-00200, 09990-00300
Sub-Wire Harness C And I Diagram
(b) Connect the red cable of the checker to the battery positive (+) terminal and black cable to the negative (-) terminal. Connect the black cable of
the sub-wire harness to the battery negative (-) terminal or body ground.
(c) Place the "SHEET A" (SST) on the actuator checker.
SST 09990-00163
5. Inspect Brake Actuator operation.
(a) Start the engine, and run it at idle.
