Corolla Sedan 4-Door L4-1587cc 1.6L DOHC MFI (1997)
DISTRIBUTOR INSTALLATION
1. SET NO.1 CYLINDER TO TDC/COMPRESSION Turn the crankshaft clockwise. and position the slit of the intake camshaft as shown in the
illustration.
2. INSTALL DISTRIBUTOR
(a) Install a new O-ring to the distributor housing.
(b) Apply a light coat of engine oil on the O-ring.
(c) Align the cutout portion of the coupling with the groove of the housing.
(d) Insert the distributor, aligning the bolt hole of the flange with that of the bolt hole on the cylinder head.
(e) Tighten the mounting bolt.
Torque: 20 N.m (200 kgf.cm, 14 ft.lbf)
3. CONNECT HIGH-TENSION CORDS TO DISTRIBUTOR CAP
4. CONNECT DISTRIBUTOR CONNECTOR
5. CHECK IGNITION TIMING
