Corolla Sedan 4-Door L4-1587cc 1.6L DOHC MFI (1997)
(b)
Remove 5 screws and the console box.
3.
Remove bracket No. 2.
(a)
Remove 3 bolts and bracket No. 2.
4.
Remove air bag sensor assembly (computer).
(a)
Disconnect the air bag sensor connector.
(b)
Remove the 3 torx screws and then remove the air bag sensor assembly (computer).
Torx wrench: T-40 (Part No. 09042-00020)
5.
Install a new air bag sensor assembly (computer).
NOTE:
^
Installation of the connector is done with the air bag sensor(computer) installed.
^
Make sure the air bag sensor (computer) is installed to the specific torque:
21 N-m (210 Kg-cm, 15 ft-lb).
^
Do not install an air bag sensor(computer) that has been dropped, or if there are cracks, dents or other defects in the case, bracket, or connector,
replace the air bag sensor (computer) with a new one.
^
When installing the air bag sensor (computer), take care that the SRS wiring does not interfere with other parts and is not pinched between other
parts.
^
After installation, shake the air bag sensor(computer) to make sure there is no looseness.
