Corolla Sedan 4-Door L4-1587cc 1.6L DOHC MFI (1997)
d. Remove the RH and LH rack ends.
16. Install RH and LH claw washers and rack ends.
17. Install RH and LH rack boots, clamps and clips.
a. Ensure that the steering rack hole is not clogged wit grease.
NOTE: If the hole is clogged, the pressure inside the boot will change after it is assembled and the steering wheel turned.
b. Install the boot.
CAUTION: Be careful not to damage or twist the boot.
c. Tighten a new clamp as shown in the illustration with a clamp opening of 2-5 mm (0.08-0.20 inch).
18. Install RH and LH tie rod ends and lock nuts. )
19. Install 2 turn pressure tubes Using SST 09633 - 00020.
[torque: 23 Nm (17 ft. lbs.)].
NOTE:
^
Use a torque wrench with a fulcrum length of 250 mm (9.84 inch).
^
This torque value is effective in case that SST is parallel to a torque wrench.
Inspection and Replacement
CAUTION: When using a vise, do not overtighten it.
NOTE: This procedure can only be performed after disassembly of the steering gear.
