Corolla Sedan 4-Door L4-1587cc 1.6L DOHC MFI (1997)
b. Using SST 09350-10010 (09556-10010), 09950-60010 (09951-00460), 09950-70010 (09951-07150) and a press, install a new side bearing.
4. Install ring gear on differential case, as follows:
a. Clean the contact surface of the differential case.
b. Heat the ring gear in boiling water.
c. Carefully remove the ring gear from the water.
d. After the moisture on the ring gear has completely evaporated, quickly install the ring gear to the differential case.
NOTE: Align the matchmarks on the differential case and contact the ring gear.
e. Temporary install the eight set bolts.
NOTICE: The ring gear set bolts should not be tightened until the ring gear has cooled sufficiently.
f.
After the ring gear has cooled sufficiently, torque the ring gear set bolts uniformly and a little at a time.
Torque: 77 Nm (57 ft. lbs.).
5. Inspect differential side bearing preload, as follows:
a. Install the differential case assembly to the transaxle case.
b. Install the transmission case.
c. Install and torque the case bolts.
Torque: 29 Nm (22 ft. lbs.).
d. Using SST 09564-32011 and a torque wrench, measure the preload.
Preload (at starting):
New bearing: 0.8-1.6 Nm (6.9-13.9 inch lbs.).
