Corolla Sport RWD L4-1587cc 1.6L DOHC (4A-GE) (1986)
/Page-484002.png)
Fig. 20 Installing inboard pad. Corolla RWD
b. Install inboard pad as shown in Fig. 20.
c. Torque caliper attaching bolt to 14 ft. lbs.
d. Adjust parking brake automatic adjuster by fully pulling and releasing parking brake lever.
Caliper, Replace
1.
Raise and support rear of vehicle, then remove tire and wheel assembly.
2.
Disconnect brake hose from brake tube and caliper using a suitable tool.
3.
Remove brake pads, refer to "Pads, Replace" procedure.
4.
Remove main pin boot, then lift and push out caliper from main pin.
5.
Reverse procedure to install, then bleed brake system.
Rotor Disc, Replace
1.
Remove caliper as described under "Caliper, Replace" procedure.
2.
Remove caliper mounting bracket.
3.
Lift off rotor disc.
