Corolla Wagon L4-107.5 1762cc 1.8L DOHC (7A-FE) (1993)
/Page-332002.png)
1. Place thermostat in water inlet housing as follows:
a. Install a new gasket onto the thermostat.
b. Align the thermostat jiggle valve with the upper side of the stud bolt, and insert the thermostat in the water inlet housing.
NOTE: The jiggle valve may be set within 10° of either side of the prescribed position.
2. Install water inlet. Install the water inlet with the 2 nuts. Torque to 9.3 Nm (82 inch lbs.).
3. Connect ECT switch connector.
4. Fill radiator with engine coolant.
5. Start engine and check for leaks.
