Corolla Wagon L4-107.5 1762cc 1.8L DOHC (7A-FE) (1993)
/Page-235004.png)
(f) Remove the four cap nuts, seal washers, cylinder head cover and gasket.
2. SET NO.1 CYLINDER TO TDC/COMPRESSION
(a) Turn the crankshaft pulley and align its groove with the timing mark "0" of the No.1 timing belt cover.
(b) Check that the hole of the camshaft timing pulley is aligned with the timing mark of the bearing cap. If not, turn the crankshaft one revolution
(360°).
3. INSPECT VALVE CLEARANCE
(a) Check only the valves indicated.
-
Using a thickness gauge, measure the clearance between the valve lifter and camshaft.
-
Record the out - of - specification valve clearance measurements. They will be used later to determine the required replacement adjusting
shim.
Valve clearance (Cold):
Intake: 0.15 - 0.25 mm (0.006 - 0.010 in.)
Exhaust: 0.25 - 0.35 mm (0.010 - 0.014 in.)
