Corolla Wagon L4-107.5 1762cc 1.8L DOHC (7A-FE) (1993)
(a) Disconnect the PCV hoses from the cylinder head cover.
(b) Remove the four cap nuts, seal washers, and cylinder head cover with the gasket.
13. Set No.1 cylinder at TDC/Compression.
(a) Turn the crankshaft pulley and align its groove with the No.1 timing belt cover.
(b) Check that the valve lifters on the No.1 cylinder are loose. If not, turn the crankshaft pulley one complete revolution (360°).
14. Disconnect connector from ground wire on RH fender apron.
15. Remove RH engine mounting insulator.
(a) Set the jack to the engine.
HINT: Place a wooden block between the jack and engine.
(b) On vehicles with A/C, remove the nut and bracket.