Corolla Wagon L4-107.5 1762cc 1.8L DOHC (7A-FE) (1993)
/Page-107003.png)
Fig. 51 Front Air Bag Sensor Replacement
Supra
3. On Supra models, remove headlamps.
CAUTION: Work must be started after approx. 30 seconds or longer from the time the ignition switch is turned to the LOCK position and the
negative (-) terminal cable is disconnected from the battery.
NOTICE:
-
If the wiring connector of the airbag system is disconnected with the ignition switch at ON or ACC, diagnostic codes will be recorded
-
Never use airbag parts from another vehicle. When replacing parts, replace with new parts.
-
Never reuse the sensor involved in a collision when the airbag has deployed
-
Never repair a sensor in order to reuse it.
Install the sensor with the arrow on the sensor facing toward the front of the vehicle.
Torque: 25 N.m (260 kgf.cm, 19 ft.lbf)
NOTICE:
-
Make sure the sensor is installed to the specified torque.
-
If the sensor has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor with a new one.
-
The sensor set bolts have been anti-rust treated. When the sensor is removed, always replace the set bolts with new ones.
-
After installation, shake the sensor to check that there is no looseness.
-
The front sensor is equipped with an electrical connection check mechanism. Be sure to lock this mechanism securely when connecting the
