Corolla Wagon L4-107.5 1762cc 1.8L DOHC (7A-FE) (1993)
/Page-1002004.png)
17.
Mesh rack with pinion and install rack guide spring cap using suitable tool or equivalent.
18.
Count total number of pinion rotations possible and return pinion half that amount to position pinion in neutral position.
19.
Adjust total preload as follows:
a. Torque rack guide spring cap to 18 ft. lbs.
b. Return rack guide spring cap 25°.
c. Measure total preload within on rotation from neutral position in both directions. Preload should be 6.9-11.3 inch lbs.
d. If preload is insufficient, retorque guide spring cap and return slightly less than 12°.
e. If preload is excessive, return rack guide spring cap slightly.
20.
Apply liquid sealer on locknut thread and rear housing surface. Install locknut and torque to specifications
21.
Recheck total preload. Adjust, if necessary.
22.
Install dust cover.
23.
Install claw washers and rack ends. Tighten rack end to specifications, using suitable tool, then stake claw washer.
24.
Install rack boots taking care not to damage or twist boots. Note difference between right and left boots.
25.
Install clamps and clips with open ends facing outward to avoid damage to boots.
26.
Install tie rod ends so marks are aligned. Adjust toe-in and torque locknuts to specifications.
