Corolla Wagon L4-107.5 1762cc 1.8L DOHC (7A-FE) (1993)
/Page-717006.png)
1. INSPECT RING GEAR FLANGE BUSHING
Using a dial indicator, measure the inside diameter of the flange bushing.
Standard inside diameter: 19.025 - 19.050 mm (0.7490 - 0.7500 in.)
If the inside diameter is greater than maximum, replace the flange.
2. REMOVE RING GEAR FLANGE
a. Using a screwdriver, remove the snap ring.
b. Remove the flange from the ring gear.
3. INSTALL RING GEAR FLANGE
a. Position the flange onto the ring gear.
b. Using a screwdriver, install the snap ring.
