Corona L4-2366cc 22R (1982)
1.
Remove differential cover or carrier as necessary.
2.
Measure ring gear runout. If excessive, remove ring gear from carrier.
Specification:
0.07 mm (0.0028 in.)
3.
Measure differential carrier runout at the ring gear mounting face. Also, check for any foreign material or burrs which may have prevented ring
gear from seating correctly.
4.
If differential carrier runout is within specification, replace ring and pinion. If differential carrier runout is the cause of excessive ring gear runout,
replace carrier assembly. Recheck vibration.
Specification:
0.07 mm (0.0028 in.)
Ring Gear
5.
If ring gear runout is within specification, check ring gear backlash. If ring gear backlash is not within specification, adjust as necessary.
Specification:
0.13-0.18 mm (0.0051-0.0071 in.)
6.
Recheck ring gear backlash at every tooth on ring gear. If ring gear backlash variation is excessive, replace ring and pinion.
Specification:
0.1 mm (0.004 in.)
Procedure K - Axle Shaft/Hub Runout Inspection
Hub Face Runout
1.
Measure hub face runout with dial indicator. If runout exceeds specification, replace hub.
Specification:
0.1 mm (0.004 in.)
2.
Remove axle shaft from housing. Utilizing V-blocks or machine centers, measure axle shaft runout. If runout exceeds specification, replace
axle.
Specification:
1.5 mm (0.059 in.)
PART APPLICATION
Special weighted bolts from Procedure 1, Method 1, Step 6, are applicable to all models with standard rear-wheel-drive driveshafts.
PART NUMBER INFORMATION
New Part Number
Part Name
