Cressida L6-3.0L DOHC (7M-GE) (1989)
/Page-884001.png)
Brake Caliper: Service and Repair
Rear
Removal and Installation
Fig. 5 Exploded View Of Rear Disc Brake Caliper Assembly.
1.
Raise and support rear of vehicle, then remove tire and wheel assembly.
2.
Disconnect brake hose from brake tube and caliper using a suitable tool.
3.
Remove caliper attaching bolts, then the caliper, Fig. 5.
4.
Remove anti-squeal shims, brake pads with pad wear indicator, and pad support plates.
5.
Reverse procedure to install, then bleed brake system.
Disassembly and Assembly
Fig. 5 Exploded View Of Rear Disc Brake Caliper Assembly.
1.
Remove sliding bushing and boot, Fig. 5.
2.
Remove piston using compressed air. When using air pressure to remove caliper piston, place a shop towel over piston to prevent it from
flying out.
3.
Remove caliper boot and piston seal from caliper.
