Cressida L6-3.0L DOHC (7M-GE) (1989)
Ignition Cable: Testing and Inspection
Ignition Wire Removal
CAUTION: Carefully remove the ignition wires by pulling on the rubber boots. Do not bend the wire or the conductor may be broken.
Typical Wire Inspection
1.
Check the condition of the wire terminals. If any terminal is corroded, clean it and if it is broken or distorted, replace the wire.
Ignition Wire Test
2.
Connect ohmmeter probes and measure resistance.
Resistance:
25K ohms max. at 68°F (20°C)
3.
If resistance exceeds 25k ohms, replace the ignition wire.