Cressida L6-3.0L DOHC (7M-GE) (1989)
4.
Connect shock absorber to axle carrier. Tighten to specification.
5.
Install disc rotor and brake caliper aligning matchmarks on rotor axle hub. Tighten to specifications
6.
Install driveshaft locknut, locknut cap and new cotter pin.
7.
Install rear wheel, then lower vehicle and bounce rear bumper to stabilize suspension.
8.
Tighten lower suspension arms, strut rods and upper arm to specifications.
9.
Check then adjust rear wheel alignment as necessary.